"Artisan Guild" WIPs - Gaki Yhimotto, an Apprentice Arcanist, and Gyros Shipwrecker |
I decided to support this particular wargaming content creator because I already owned a number of their very characterful (some might say 'cartoony') miniatures, having previously bought them from a licensed merchant over on "Etsy". One of main motivators for buying a 3D printer was to stop me from paying others to produce the figures I wanted and having calculated what it would cost to just purchase the six Apprentice Arcanists as physical products, it was clear I'd be forking out more than an entire bottle of "Elegoo" Water Washable Resin - from which I could print approximately ten times their number.
Packing a build plate with Golemmar Gnomes and Depth Diggers. But doing the Giant Clay Golem on its own |
Not only does this membership level grant you access to an astonishing number of STL files (currently covering Lust Daemons, Ratmen and dinosaur-riding space lizards), but it also provides you with digital copies of all their different rulesets. Furthermore, "One Page Rules" have a super-handy Army Forge builder which quickly enabled me to compile a 250-point Halfling force - or rather a Gnome mining party using a combination of the figures I received from "Artisan Guild".
"Artisan Guild" WIPs - Two Depth Diggers and a (troublesome) Orc War Shrine |
Overall, this factory-line like approach served me well. But I did encounter some problems when tackling the large pieces of scenery provided with each release. As with the figures, these sculpts came pre-supported. However, I found the supports unable to resist the pull of my resin tank's FEP once the print was approximately a third of the way through, and this caused repeated failures. In the end I only successfully printed out the terrain when it was laid flat upon the build plate, and "Chitubox" Basic had provided it with sturdier supports.
No comments:
Post a Comment